Splasm Software Discussions

Ripping Error Report
Page 1 of 1

Author:  dflippo [ Mon Jan 28, 2013 12:10 pm ]
Post subject:  Ripping Error Report

Is there anyway you could provide a warning if a disc had potential skips or bad reads? Often, all that is needed is a bit of polishing, but when you have to know if it's needed. I usually visually inspect each cd before letting ABB rip it, but you never really know if it will skip or not.

Author:  Allan W. [ Mon Jan 28, 2013 3:14 pm ]
Post subject:  Re: Ripping Error Report

We can certainly look into incorporating an error message for when minor skips are detected!

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group